CHAMPION DH5000T Single Source Gas Manual - Manual (Page 14)

6
Converting Straight-through Operation to Corner Operation
! ATTENTION !
The track assembly must be converted as shown below.
This is the end of the conversion instructions.
A
Rotate 180º
Lift track assembly
up and out.
B
B
1
2
Step 1:
Open the hood and remove the
track assembly (A) by pulling straight
up and lifting the assembly out of
the machine.
Step 2:
Rotate the track assembly 180° and
reinstall it in the machine.
Step 3:
Note the location of the removal
rack guide B1 after the track
assembly has been rotated.
Step 4:
Remove the two truss-head screws
holding the rack guide B1 in place.
Save the fasteners.
Step 5:
Rotate the rack guide counter-
clockwise 90° to its new position
B2.
Step 6:
Using the fasteners saved in Step 4,
secure the guide to the track
assembly.
Installation