CHAMPION DH5000T Single Source Gas Manual - Manual (Page 33)

25
Operation
Rinse Sentry Operation Mode
The final rinse water temperature must be a minimum of 180ºF/82ºC during the final rinse cycle
to ensure all wares are sanitized. If for any reason, the hot water temperature in the booster tank
cannot provide this temperature, the dishwasher will enter a Rinse Sentry Mode of operation and
extend the cycle time.
The Rinse Sentry changes the Standard and Heavy Duty cycle time as described below:
1. The Rinse Sentry constantly monitors the water temperature inside final rinse booster.
2. If the temperature inside the booster heater falls below 180ºF/82ºC, the Rinse Sentry
will extend the wash cycle time until the booster heater water temperature reaches the
proper temperature.
3. The CYCLE light will remain illuminated during the Rinse Sentry Mode.
4. The RINSE water temperature display must be monitored to ensure a minimum of
180ºF/82ºC is maintained during the rinse cycle.
5. The acceptable temperature range for the final rinse water is 180-195ºF/82-91ºC.
6. A wash cycle time of more than 6 minutes may indicate a low incoming water temperature
or a problem with the booster tank operation.
! VERY IMPORTANT !
DO NOT REMOVE WARES UNTIL THE FINAL RINSE CYCLE HAS
SANITIZED THE WARES AND THE GREEN CYCLE LIGHT GOES OUT.
! NOTE !
A wash cycle time of more than 6 minutes may indicate a low incoming water temperature or a
problem with the booster tank operation.