CHAMPION DH5000T Single Source Gas Manual - Manual (Page 32)

24
Operation
Heavy Duty Wash Cycle Operation (continued)
11. Close the hood, the green CYCLE light will illuminate and the heavy duty wash
cycle will begin automatically. The wash cycle time runs for the selected time.
12. Opening the hood when the dishwasher is in-cycle will pause the cycle. The cycle will
resume automatically when the dishwasher hood is closed.
13. The final rinse cycle begins at the end of the wash cycle and runs for approximately
10 seconds followed by a 15 second delay before the green CYCLE light goes out.
14. Check the FINAL RINSE temperature gauge during the final rinse and make sure it indicates
a minimum of 180ºF/82ºC. The acceptable range of operation is 180-195ºF/82-91ºC.
15. Check the pressure gauge located below the temperature displays to ensure the
final rinse pressure maintains a flowing pressure between 20-22 PSI.
16. At the end of the rinse cycle, the in-cycle light will go out. Open the hood and remove
the clean rack of wares.
17. Repeat steps 9-16 for additional dish racks.
18. Refer to the Automatic Drain Cycle on page 21 for the procedures to drain the dishwasher.
10
0
30
20
PSI
60
50
40
RINSE
180°F
1 8 0
I
O
1 5 0 1 7 0
WASH
150°F
RINSE
180°F