CHAMPION DH5000T Single Source Gas Manual - Manual (Page 23)

15
Initial Start-up Check List
Initial Start-up
IMPORTANT
During the initial fill, adjust the PRV to ensure the flowing pressure of the incoming water is set
between 20-22 PSI.
Make sure the pump suction strainer is in place.
Make sure the scrap screen plate is mounted in the center of
the wash tank and separating the scrap screens.
Make sure the scrap screens are in place.
Make sure the drain screen is clean.
1. Remove any protective film from dishwasher. Check the interior for foreign material.
2. Make sure the dishwasher is permanently located.
3. Make sure all utility connections are complete.
4. Make sure the chemical supply containers are full.
5. Make sure the pump suction screen is in place.
6. Make sure the drain screen is clean and unobstructed by debris.
7. Make sure the scrap screen plate and scrap screens installed and firmly seated.
The screen plate is mounted in the center of the wash tank and locks in a slot on the
back screen support.
8. Make sure the spray arms are in place and spin freely.
9. Close the dishwasher hood.
10. Turn hot water supply on and check for leaks in the main water supply piping connected
to the dishwasher.