CHAMPION DH5000T Single Source Gas Manual - Manual (Page 12)

4
Refer to the illustration below and on the next two pages to convert a straight-through operation
machine to a corner operation machine.
To convert the dishwasher:
1. Place the dishwasher as shown below so the control panel faces into the room
and is accessible to the operator.
2. Position the dishwasher so the machine and the dish tables align correctly according
to the required positioning of the dish tables to the walls.
3. Make the utility connections as described in this manual and in accordance with all
local codes and regulations.
4. Install the dish tables so the edge of each table fits over the inner wall of the dishwasher
tank.
5. Secure the dish tables to the dishwasher
6. Seal each dish table joint with a food-grade sealant to prevent leaks.
Installation
Converting Straight-through Operation to Corner Operation
! ATTENTION !
A straight-through machine can be converted to a corner configuration in the field.
Corner Operation Shown
Control
Panel