Heidolph Hei-VAP Precision - Manual (Page 11)

Set-up and Start-up Set-up and Start-up
20 21
Included with the equipment:
Description Quantity Order number
Vapor tube coupling clamp with swing clamp 1 23-09-03-01-03
Tension spring 1 22-03-02-01-05
PTFE 26 vacuum seal 1 23-30-01-01-30
Clamping piece 26 1 23-30-01-05-31
Operating instructions Hei-VAP Value /
Hei-VAP Advantage
1 01-005-004-79
Operating instructions Hei-VAP Precision 1 01-005-004-92
Warranty / declaration of non-objection 1 01-006-002-58
Description Quantity Order number
Power cable (EC) 1 14-300-009-81
Power cable for the US 1 14-300-009-82
Power cable for GB 1 14-300-009-83
Power cable for Switzerland 1 14-300-009-84
Description Quantity
Order No.
Standard NS 29 Order No.
NS 24
Swing clamp 1 23-30-01-05-29 23-30-01-05-57
Table 4-1: Scope of delivery
Description Quantity
Order No.
Standard NS 29 / 32 Order No.
NS 24 / 40
Glassware set G1 1 513-00100-00 513-00140-00
or Glassware set G3 1 513-00300-00 513-00340-00
or Glassware set G5 1 513-00500-00 513-00540-00
or Glassware set G6 1 513-00600-00 513-00640-00
or
Glassware set G1
coated
1 513-00110-00 513-00150-00
or
Glassware set G3
coated
1 513-00310-00 513-00350-00
or
Glassware set G5
coated
1 513-00510-00 513-00550-00
or
Glassware set G6
coated
1 513-00610-00 513-00650-00
Accessories
Unpack the rotary evaporator and check for any potential shipping damages and that
all components were included.
Inform the Service Department of Heidolph Instruments in case of any damages
(see chapter “Maintenance, cleaning, service” – “Service”).
Description Quantity Order number
Upgrade kit Advantage Precision-HL 1 569-30009-00
Upgrade kit Advantage Precision-ML 1 569-40009-00
Table 4-2: Accessories
Transport
The motor lift units have a transportation safety device, which must be removed prior
to the initial start-up of the unit or reattached prior to the return shipment. This is very
important in shipping any return or repair of motor lift unit to make sure transport lock is
assembled.
A brief description of the procedure for removing and reattaching the transportation
safety device may be found in the following.
The transportation safety device consists of three M5x8 screws and a connecting plate
with holes for fixing the position.