Heidolph Hei-VAP Precision - Manual (Page 51)

Dismantling, storage, disposal
100 101
Dismantling, storage, disposal
Remove the Woulff bottle
Remove the Woulff bottle in reverse sequence of the assembly (see chapter “Set-up
and start-up” – “Glassware sets”).
Disconnecting the coolant / vacuum
1. Verify that the coolant and vacuum supply is switched off and that the system is at
atmospheric pressure.
2. Disconnect the tubes from the condenser and drain coolant safely into a storage
container.
Remove the heating bath
Remove the heating bath in reverse sequence of the assembly.
WARNING Glass breakage!
Cuts.
Work carefully.
WARNING Hot surfaces!
Scalding and burns.
Cool the heating bath.
Glassware set
The glassware set may be stored in a dry location.
Empty and clean the glassware set.
Store the glassware set in the original packaging.
Close the packaging with adhesive tape.
Properly dispose of the unit according to the valid national and legal regulations
pertaining to disposal of used laboratory equipment.
Evaporator
The unit may be stored in a dry location.
Store the unit in the original packaging (only possible with the transportation
protection device attached).
Close the packaging with adhesive tape.
Storage
Disposal