INFICON HLD6000 Refrigerant Leak Detector Interface Description - Manual (Page 30)

30 Fieldbus Communication
4 Fieldbus Communication
4.1 Preface
In order to use fieldbus communication with HLD6000, you need an INFICON Bus-
Module BM1000 connected to the I/O port of the HLD6000.
Fieldbus systems normally support device-specific configuration files e.g. GSD files
for the PROFIBUS field bus system.
You will find the appropriate configuration files on the USB memory stick which is
supplied with your HLD6000. For example IFCN0E8D.GSD file for PROFIBUS.
4.2 Setup
► Select the “Bus“ at the HLD6000 display page
“Settings > Setup > Interfaces > Device sel. > Module at M12 connectorˮ.
► Select the field bus address at the HLD6000 display page
“Settings > Setup > Interfaces > Bus Module > Addressˮ.
Attention:
Address and profile do not come into effect until a restart of the leak detector (power
off/power on)!