INFICON STM-2 USB Thin Film Rate/Thickness Monitor - Manual (Page 21)

2 - 1
PN
07
4-
61
3-
P1
A
STM-2 Operating Manual
Chapter 2
Installation
2.1 Installation Requirements
2.1.1 Parts Requirements
 STM-2 Monitor
 One crystal sensor with feedthrough
 One oscillator kit for the crystal sensor
NOTE: The oscillator kit is not required when using the internal oscillator.
 Quartz crystals appropriate for the application
 One Windows computer meeting minimum specifications (refer to section 1.4
on page 1-5 ).
CAUTION
To maintain proper STM-2 performance, use only
the provided 15.2 cm (6 in.) BNC cable to connect STM-2
or the oscillator to the crystal sensor.
The length of the in-vacuum cable (Front Load and
Sputtering sensors) or electrical conduit tube
(Cool Drawer and Bakeable sensors) must not exceed
78.1 cm (30.75 in.).