INFICON STM-2 USB Thin Film Rate/Thickness Monitor - Manual (Page 27)

3 - 1
PN
07
4-
61
3-
P1
A
STM-2 Operating Manual
Chapter 3
STM-2 Software Operation
3.1 Introduction
INFICON STM-2 Software is capable of interfacing up to eight STM-2 instruments
to display Rate, Thickness, Frequency, and Crystal Life for the connected sensors.
STM-2 Software has independent Density, Z-Ratio, and Tooling parameters for
each STM-2 to allow for codeposition monitoring capabilities.
3.2 Installing INFICON STM-2 Software
3.2.1 Installing the Protocol Server
1 Insert the Thin Film Manuals CD into the CD drive on the computer that will
be connected to STM-2.
2 Click Windows Explorer or
File Explorer >> Computer >> (CD drive letter:) >> Common Software.
3 Double click setup_smdp_svr_lv.exe. The Zip Self-Extractor window will
display.
4 Click Unzip. The SMDP Serial Protocol Server window will display.
5 On the Destination Directory pane, click Browse to select the location where
all software will be installed.
6 Click Next.
7 Read the license agreement.
8 Click I accept License Agreement(s).
9 Click Next.
10 Review the summary of information.
11 Click Next. Installation Complete will display.
12 Click Next. The Setup Wizard pane will display.
13 Click Next. The Confirm Installation pane will display.
14 Click Next.
15 Read the license agreement.
16 Click I Agree.
17 Click Next. Installation Complete will display.
18 Click Close.
19 Click Close on the Zip Self-Extractor.