INFICON STM-2 USB Thin Film Rate/Thickness Monitor - Manual (Page 58)

4 - 10
PN
07
4-
61
3-
P1
A
STM-2 Operating Manual
4.3.2 Operate
Figure 4-8 Operate tab
Change Film . . . . . . . . . . . . . . . . . . Changes the active film. Clicking this opens
the FilmPicker.vi window that displays films
to run (see
Figure 4-9 ). Existing thickness is
not zeroed, the thickness is recalculated with
the new Z-Ratio and tooling.
Figure 4-9 FilmPicker.vi window
NOTE: If a film is not displayed in this
window, the film will need to be
added by clicking Edit Films on the
Films tab (see
section 4.3.3 ).