2 system connections, 1 internal oscillator – INFICON STM-2 USB Thin Film Rate/Thickness Monitor User Manual
Page 22
2 - 2
PN
07
4-
61
3-
P1
A
STM-2 Operating Manual
2.2 System Connections
STM-2 can be configured to use either an internal or external oscillator depending
on the internal jumpers. The default jumper setting is to use the internal oscillator.
2.2.1 Internal Oscillator
1
Connect the (provided) USB cable to a computer USB port and to STM-2.
2
Use the (provided) 15.2 cm (6 in.) BNC cable to connect STM-2 to the sensor
feedthrough (see
).
Figure 2-1 Internal oscillator
3
Install and run STM-2 Software or STM-2 LabVIEW Application (see
NOTE: STM-2 Software and STM-2 LabVIEW can be installed and run on the
same computer without interference.
4
The PWR indicator on STM-2 illuminates (see
5
The USB indicator on STM-2 illuminates (see
).
USB
USB
Cable
BNC Cable
Maximum Length
15.2 cm (6 in.)
Substrate
Source
Sensor
Jumpers set
for internal oscillator