INFICON XTC/3 Thin Film Deposition Controller Software Editor Operating Manual - Manual (Page 18)

1 - 6
IP
N 07
4-
45
2-
P1
A
XTC/3 Editor Operating Manual
1.7 How To Install The XTC/3 Editor
Install the XTC/3 Editor from within Windows as follows:
NOTE: Administrative or Standard user rights are required to install the XTC/3
Editor on a system running Windows 2000 or XP system.
NOTE: This description assumes that the CD-ROM drive is drive “d”. If it is not “d”,
substitute the appropriate drive letter.
1 Insert the CD into the CD-ROM drive.
2 Select Start >> Run... to display the Run dialog
3 In the Open field, type d:\setup
4 Select OK.
5 When prompted, answer the questions.
NOTE: If prompted during the installation to replace a system file (e.g. a DLL
file), it is recommended that the file be replaced. Normally this prompt
is only presented if the file on the hard disk is older than the file on the
installation disk. The newer version should still work with older
programs that use this file; however, if you are concerned that it may
cause problems, abort the installation, save a copy of the file in
question, and restart the installation program.
CAUTION
The XTC/3 Editor may not function properly if all files are
not installed.
When the installation is complete, put the original CD in a safe storage area.