INFICON XTC/3 Thin Film Deposition Controller Software Editor Operating Manual - Manual (Page 71)

4 - 9
IP
N 07
4-
45
2-
P1
A
XTC/3 Editor Operating Manual
Figure 4-13 Recalling a Data File
After a data file is opened, the data cursor can be used to display numeric data for
any scan of data contained in the file. The cursor can be repositioned by pressing
and holding the left mouse button when over the Data Cursor, dragging the Data
Cursor, and releasing the mouse button. The left and right arrow keys can also be
used to move the Data Cursor once it has been repositioned on the graph.
Figure
4-14 shows the Data Cursor repositioned.
Figure 4-14 Recall, Cursor Use
Line Cursor