INFICON XTC/3 Thin Film Deposition Controller Software Editor Operating Manual - Manual (Page 34)

2 - 10
IP
N 07
4-
45
2-
P1
A
XTC/3 Editor Operating Manual
Figure 2-11 Com Properties: Controllers tab
The Controllers tab (refer to Figure 2-11 ) allows for a Controller to be removed
(using the Remove Controller button) or edited (using the Edit Controller button).
When editing the Controller, changes can be made to the Controller Name, which
is used to identify the Controller in the software. The AutoDetect tab (see
Figure
2-12 ) allows XTC/3 Editor communications to streamline the detection of a
controller at a serial port.
Figure 2-12 Com Properties: AutoDetect tab