INFICON XTC/3 Thin Film Deposition Controller Software Editor Operating Manual - Manual (Page 42)

2 - 18
IP
N 07
4-
45
2-
P1
A
XTC/3 Editor Operating Manual
2.4.3 Access Levels
The XTC/3 Editor can be operated from one of two Access Levels — Advanced or
Normal. These levels provide protection against modifications of controller
configurations and System Setup. An Advanced user may want to completely set
up the system and then set the Access Level to Normal for the system operators.
The XTC/3 Editor system can be password protected to operate at one of two
access levels:
Š
Advanced. All system controls are available. The system may be controlled
manually while in Advanced mode.
Š Normal. A limited set of system controls are available. Major functionality that
is not available to a Normal user includes Edit Configuration and any
changes to the System Setup. Many functions are available but provide
read-only access at the Normal Access Level.
To change the security level, select Tools >> Set Access Level.... See Figure
2-17 .
Figure 2-17 Tools >> Set Access Level
The Change Access Level dialog will display the current security level. In Figure
2-18 the Current Access Level is set to Advanced.
Figure 2-18 Change Access Level Dialog
When changing from Normal level to Advanced level, enter the correct password
in the Password: field and click OK. To change a Password, click the Change
Password... button, enter the old Password and the new Password in the
appropriate boxes, and click OK. As with any password, it should be remembered
and protected.