INFICON XTC/3 Thin Film Deposition Controller Software Editor Operating Manual User Manual
Page 30
Advertising
2 - 6
IP
N 07
4-
45
2-
P1
A
XTC/3 Editor Operating Manual
Figure 2-6 Ethernet Communication Properties
After typing the IP address of the XTC/3 instrument, click on Add. The Controller’s
IP Address is then added to the list.
If the Remove button is clicked, the highlighted Controller’s IP Address is removed
from the list.
Figure 2-7 Reset Interface Button
Clicking on the Reset Interface button resets the Controller’s Ethernet parameters
to their default values.
When the OK button is selected, the Controller(s) at that IP Address is physically
added. (See
). An icon is added for each new controller.
Advertising