INFICON XTC/3 Thin Film Deposition Controller Software Editor Operating Manual - Manual (Page 74)

4 - 12
IP
N 07
4-
45
2-
P1
A
XTC/3 Editor Operating Manual
Enter the step size in the Scan Step Size box. Enter 1 to report every scan, 2 to
report every other scan, etc. For single files, the actual limits are displayed in the
SOD Info box. However, since multiple files may have different limits they are left
blank if more than one file is selected. If the ranges selected exceed the actual
limits of one of the files in a group, the points that fall within the specified ranges
are reported and no error is displayed.
The Multiple files if #scans is > 63000 check box is for files that contain more than
63000 scans in order to account for older Excel applications that cannot display
more than 65000 lines. Multiple files with a maximum of 65000 lines will be
generated.
Click on the Data Format tab to display the Data Format page, shown in Figure
4-17 , used to select the formatting options and the type of data for the report.
Figure 4-17 Generating a Report - Setting the Data Format
The data can be oriented in Columns or Rows. Selecting Columns places the
measurements for each parameter in separate columns with one scan per row.
Selecting Rows generates a series of parameter-measurement pairs, grouped by
scan. The delimiter between columns can be selected as either Tabs or Commas.
Sensor Status, Tic Time and Sensor State data can also be generated and
displayed in separate columns if the corresponding boxes are checked.