9 how to start the xtc/3 editor – INFICON XTC/3 Thin Film Deposition Controller Software Editor Operating Manual User Manual
Page 22
1 - 10
IP
N 07
4-
45
2-
P1
A
XTC/3 Editor Operating Manual
1.9 How To Start The XTC/3 Editor
To start the XTC/3 Editor select Start >> Programs >> XTC3 Application >>
XTC3 (see
Figure 1-1
).
HINT: You may want to make a shortcut to XTC/3 Editor on your desktop to
facilitate starting the program in the future. See the Windows
documentation for instructions on how to create shortcuts.
When upgrading the XTC/3 Editor program it is not possible for the
installation program to upgrade existing shortcuts. After an upgrade, an
existing shortcut will not work if the XTC/3 Editor is installed in a folder that
is not the folder pointed to by the shortcut.
Figure 1-1 Starting XTC/3Editor
The first time XTC/3 Editor is run on a computer, it will start in the setup screen with
the communication configuration dialog displayed.
See
for information on how to configure the communications interface,
individual controllers and user preferences.