INFICON XTC/3 Thin Film Deposition Controller Software Editor Operating Manual - Manual (Page 46)

3 - 4
IP
N 07
4-
45
2-
P1
A
XTC/3 Editor Operating Manual
open an existing Configuration file select Open; to create a new Configuration from
scratch select New. The item <Unknown Controller> is highlighted by default when
the Edit Configuration dialog appears. To edit a configuration for a known
Controller (e.g. XTC/3 1 in
Figure 3-6 ), highlight the Controller entry and press
Open. This will open a File Open dialog, as shown in Figure 3-7 , in the appropriate
folder for this Controller.
Figure 3-6 Selecting A New Or Existing Configuration
Selecting New will open the Configuration Editor immediately to the main window
(see
section 3.3 on page 3-5 ).
Figure 3-7 Selecting A Configuration To Open
If the Files of type box does not show a XTC/3 Configuration ( *.xtc ) or All Files
(*.*), then click on the pulldown and select one of these types from the list. Clicking
on a filename will display a few lines of text in the preview box which describe the
Configuration. Once a file is selected and opened, the main window of the
Configuration Editor will be displayed (see
Figure 3-8 ).