INFICON XTC/3 Thin Film Deposition Controller Software Editor Operating Manual - Manual (Page 20)

1 - 8
IP
N 07
4-
45
2-
P1
A
XTC/3 Editor Operating Manual
. . . . . . . . . . . . . . . . . . . . . . . Radio buttons. These buttons are used to
accept a single selection from at least two
choices. Radio buttons are often grouped
according to functionality and sometimes
enable other controls based on the choice
selected. If radio buttons are shown, but are
disabled (greyed), then they are being used
to show a status not selectable by the user.
. . . Spinners. Spinners are a pair of triangles
pointing up and down. These are used to
increase or decrease a parameter. Most
often used with an entry box, spinners only
act upon the entry box selected with the
mouse pointer. When two or more entry
boxes are on the same line as the spinner,
the mouse pointer must be used to select an
entry box before the spinners will change the
value in that box. When an entry box
contains a value with punctuation (e.g. a
value of time), the spinners act upon each
piece of the value individually. Some entry
boxes that use spinnners can also be directly
edited.
HINT: When editing from the keyboard, the Alt+UpArrow key combination
will increase the value (except for Time spinners). The
Alt+DownArrow key combination will decrease the value.
. . . . . . . . . . . . . . . . . . . Toolbar. A collection of buttons that is often
visible for an associated functionality and
invisible when that function is inactive.
Toolbars can be moved with the mouse
pointer or made visible/invisible from a menu
selection.