Leica Biosystems RM2265 - Manual (Page 40)

38 Instructions for Use, V 1.8 RevC – 07/2013
5. Operation
There are two versions of the specimen holder
fixture, one with and one without specimen ori-
entation, which are interchangeable.
The specimen orientation allows for simple posi-
tion correction of the specimen surface when the
specimen is clamped into place.
You can use the specimen holder fixture (60) to
hold all available accessory specimen clamps
(for additional information, refer to Chapter 6
"Optional Accessories" ).
To do so, proceed as follows:
• Move the specimen holder fixture (60) to the
upper end position by turning the handwheel
(12) and engage the handwheel lock.
• To release the clamping system, turn the
screw (61) counterclockwise using an Allen
key size 4 (71).
• Push the guide (63) of the standard clamp (62)
from the left into the specimen holder fixture
(60) as far as it will go.
• To clamp the specimen clamp, tighten the
screw (61) in a clockwise direction using an
Allen key size 4 (71).
5.3 Inserting the standard clamp
71
63
62
60
12
61 60
Fig. 25