Instrument setup – Leica Biosystems RM2255 User Manual
Page 19
17
Leica RM2255
6
5
4.3 Unpacking and installation
(cont.)
Fig. 10a
7
9
• Take out the fixing module (5). To do so, hold
it by the top edge of the module and in the
recessed grip (6) and pull it out by pulling
upwards.
• Lift the instrument (7) by holding it by the
base plate and under the instrument on the
back and lift it out of the formed cushion (8).
• Place the instrument on a stable laboratory
table.
The two sliding elements (9) located on the
rear of the base plate make it easier to move
the instrument on the table.
• To move the instrument, hold it by the front
of the base plate, lift it up gently and slide
it on its slides.
4. Instrument Setup
Never hold the instrument for
transport by the handwheel or the
rotary knob for section thickness
adjustment.
Observe the correct resting angle
to the table to avoid pinching your
fingers.