1 not ready to switch on, Not ready to switch on, Not ready to switch – Lenze E94AxHE Technology Application CiA402 Device profile User Manual
Page 55
EDS94TA11010xxxx EN 1.2 - 03/2010
L
55
9400 Technology applications | CiA402 device profile
Parameter setting & configuration
Device control
3.7.3.1
Not ready to switch on
This is the controller status directly after switching on the supply voltage.
In this device state the operating system is initialised.
The monitorings are not active yet.
Communication is not possible yet.
The controller cannot be parameterised yet and no device commands can be executed.
The motor brake, if available, is closed.
The operation is inhibited.
Bit pattern for "Not ready to switch on" device state in
(status word):
Bit 7
Bit 6
Bit 5
Bit 4
Bit 3
Bit 2
Bit 1
Bit 0
Warning
Switch on
disabled
Quick stop
Voltage
enabled
Fault
Operation
enabled
Switched on
Ready to switch
on
X
0
X
X
0
0
0
0
Note!
When the device initialisation is completed, the device state is automatically
changed to "