MTS Acumen - Manual (Page 113)

Warning :
You must turn limits on after setting limit values.
Failure to turn limits on after setting the values could result in equipment damage or injury.
After turning the limits on, always verify that the sliders are blue (active) and not grey
(disabled).
Set Up Meters and the Scope
1. If axial force and axial displacement meters are not shown at the bottom of the MPX main window, click
the Expand button in the bottom center of the window.
2. Right-click the Axial Force meter and select Zero Signal.
MTS Acumen ™ | 113
Running the Example Spring Test