MacDon Transport 25 ft 972 - Manual (Page 11)

SET-UP INSTRUCTIONS
Form # 131126 Issue 11/07 9
RIGHT END (REAR) WHEEL (continued)
6. Install right wheel assembly as shown below:
• Install 3/4 x 4-1/2” hex head bolt through wheel assembly and new 0.812” hole in endsheet.
Position plate (G) on outside face of endsheet and secure with 3/4 nut (E).
NOTE: If necessary, elongate hole in endsheet horizontally as required to fit.
• At new 0.75” hole in endsheet, install 5/8 x 1-1/4 hex head bolt (F) and secure with nut (H).
NOTE: For double sickle drive headers use top hole in plate (G) and rear hole in support (J) as
shown. For single sickle drive headers, use lower hole in plate (G) and forward hole in support (J).
• At bolt welded to frame tube, use one 5/8 flange nut (L) to secure brace tube.
RIGHT WHEEL ASSEMBLY