MacDon Transport 25 ft 972 - Manual (Page 19)

SET-UP INSTRUCTIONS
Form # 131126 Issue 11/07 17
RE-ROUTE HEADER HOSES AND HARNESS
1. At left header leg, remove reel lift hose and
header wiring harness from their clamped
position at (A). Remove female 1/4” quick
coupler from reel lift hose.
2. Re-route reel lift hose and header wiring
harness into v-channel under main tube and out
rectangular hole at (B). Reinstall quick coupler
on reel lift hose.
3. Remove clamp from draper drive hoses at (B).
4. Install new support (C) as shown, using existing
hardware. Remove female quick coupler from
draper drive hose and install on support (C)
with dished washer (D) positioned as shown
below. Install insulated clip (E) with 3/8 x 3/4”
carriage bolt and flange nut to attach reel lift
hose and header wiring harness.
5. Connect harness extension (F) from kit [1200
mm, (48”) long] to header harness and tie to
draper drive hose and reel lift hose as shown.
HOSE / HARNESS ROUTING
A
B
F
HOSE / HARNESS ROUTING
C
F
HOSE / HARNESS ROUTING
E
D