MacDon Transport 25 ft 972 - Manual (Page 8)

SET-UP INSTRUCTIONS
Form # 131126 Issue 11/07 6
LEFT END (FORWARD) WHEEL (continued)
15. Install left wheel assembly as shown below:
• At the two holes in bottom flange of endsheet, use two 5/8 x 1-1/4 carriage bolts at (H) (heads
down) and 5/8 flange nuts.
• At hole in side of left endsheet, use one 5/8 x 2” hex head bolt (D), 5/8 flat washers (F) (three for
single sickle & four for double sickle headers), and 5/8 flange nut (G).
• At bolt welded to frame tube, use one 5/8 flange nut (J) to secure brace tube.
• Attach storage bracket to rear of left endsheet with two 1/2 x 1 inch short neck carriage bolts and
1/2 flange nuts at (K).
NOTE: For single sickle headers, If not present, drill 0.531” hole (L) at dimensions shown. For
double sickle drive headers, at top bolt, use the existing belt tension adjusting bolt to secure
bracket.
LEFT WHEEL ASSEMBLY
Three required for Single Sickle
Four required for Double Sickle.