MacDon Transport 25 ft 972 - Manual (Page 29)

CONVERTING TO TRANSPORT
Form # 131126 Issue 11/07 27
14. Install front transport wheel at cutterbar, aligned with R/H header leg as follows:
• Install wheel assembly over guard tips (E) at right header leg.
• Ensure clamp is seated up inside leg.
• Operate lever (F) to engage clamp on leg plate.
15. Remove “L” pin (B), both sides and detach float
springs.
16. Disengage header lift cylinder stops.
17. Be sure area is clear of bystanders, then start
engine. Retract lift cylinders to lower header
onto transport wheels.
INSTALL FRONT WHEEL AT CUTTERBAR
DETACH FLOAT SPRINGS
B