MacDon Transport 25 ft 972 - Manual (Page 16)

SET-UP INSTRUCTIONS
Form # 131126 Issue 11/07 14
TRANSPORT LIGHTS ON HEADER (continued)
5. Install lights at R/H reel support arm using ½ x
1 inch carriage bolts and flange nuts as shown.
Mounting for 2001 and newer headers shown
in top photo. For pre-2001 headers, light mount
is attached as shown in second photo.
NOTE: For headers with floating divider option, a
different light mounting bracket is required. See
instructions packaged with dividers.
6. For 2001 and newer headers, install harness
guard as shown at (A). For pre-2001 header
install harness guard as shown at (B).
7. Install harness guard holder (G) on reel arm as
shown. Secure holder with 5/8 x 1 inch hex
head bolt and lock nut. Route harness up
inside reel support arm and over bolt (D). Pass
harness through guard to lights and make the
connections. Secure harness with plastic tie at
(C) (see inset, top photo).
NOTE: Wire colors do not match up when
connecting harness to lights. Refer to wiring
schematic on page 15.
8. For single sickle drive headers, attach Slow Moving Vehicle sign with spacer, 3/8 x 1 ¾ carriage bolt
and flange nut as shown below left.
For double sickle drive headers, drill a 0.406” hole in SMV sign, centered on base and 2.16” (55 mm)
from bottom of sign as shown at (E). Also drill a 0.406” hole in RH reel arm located 7 ½” (190 mm)
rearward of reel lift cylinder pin (F), and 3/8” (10 mm) above centerline of reel lift cylinder pin (F).
Attach sign with spacer, 3/8 x 1 ¾ carriage bolt and flange nut as shown below right.
G
D
INSTALL GUARD HOLDER
INSTALL SMV SIGN
(DOUBLE SICKLE DRIVE HEADERS)
E
F
INSTALL SMV SIGN
(SINGLE SICKLE DRIVE HEADERS)
A
INSTALL LIGHTS & HARNESS GUARD AT
R/H REEL ARM
C
B
INSTALL LIGHTS & HARNESS GUARD AT
R/H REEL ARM - Pre-2001 Header