MacDon Transport 25 ft 972 - Manual (Page 5)

SET-UP INSTRUCTIONS
Form # 131126 Issue 11/07 3
LEFT END (FORWARD) WHEEL (continued)
5. Remove left wheel assembly installed in
step 2.
6. Align holes in plate (C) (from kit) with
endsheet holes and place a 3mm (1/8”)
fillet weld all around the outside edges of
plate (C).
NOTE: Two bolts can be used in holes to
hold plate (C) during welding.
7. Align hole in plate (D) (from kit) with
endsheet hole and mate the radius of plate
with backtube. Place a 3mm (1/8”) fillet
weld around the outsides edges of plate
(D).
NOTE: A bolt can be used to hold plate (D)
in position during welding.
C
WELD OUTER SUPPORT PLATE – L/H ENDSHEET
WELD INNER SUPPORT PLATE – L/H ENDS SHEET
D