MacDon Transport 25 ft 972 - Manual (Page 15)

SET-UP INSTRUCTIONS
Form # 131126 Issue 11/07 13
TRANSPORT LIGHTS ON HEADER
1. Open left hand drive shield and route header section of transport wiring harness through inside of
frame tube to right endsheet.
NOTE: The end of the harness with the 6-way connector goes to the right endsheet.
NOTE: For European applications, the lamp module
referred to in steps 2 and 3 is not used. Header
harness connects directly to end sheet harness.
2. At the R/H end sheet, install lamp module and
support as follows: For Single Sickle Headers,
Install at (N) with the hardware that secures the
sickle storage tube as shown at right. For Double
Sickle Headers, install at clamp (V) as shown
below.
3. Connect header harness and end sheet
harness to lamp module. Route end sheet
harness to top of end sheet through hole at reel
support arm anchor (S).
4. Install lights at R/H endsheet as shown at right,
using the hardware that secures the pivoting
amber lights. Secure harness with plastic tie at
(R). NOTE: For European applications, pivoting
amber lights are not installed. Install transport
lights using hardware provided.
NOTE: Wire colors do not match up when
connecting harness to lights. Refer to wiring
schematic on Page 15.
INSTALL LAMP MODULE – Double Sickle
(EXCEPT EUROPEAN APPLICATIONS)
V
R
S
INSTALL LIGHTS AT END SHEET
INSTALL LIGHTS AT ENDSHEET
S
R
N
INSTALL LAMP MODULE – Single Sickle
(EXCEPT EUROPEAN APPLICATIONS)