MacDon Transport 25 ft 972 - Manual (Page 7)

SET-UP INSTRUCTIONS
Form # 131126 Issue 11/07 5
LEFT END (FORWARD) WHEEL (continued)
IMPORTANT: Steps 12-15 are for double sickle headers, for single sickle headers see page 4.
12. Bolt left hand caster mount (E) into position
against inside surface plate (D) welded in step 7
(refer to next page for instruction).
13. Position rectangular (100 x 68mm) gusset (G)
(from kit) 6mm (1/4”) above left hand caster mount
and flush against plate (D) and backtube. Position
the 100mm (4”) side of gusset against plate (D).
Tack gusset (G) in position.
14. Remove left hand caster mount and weld gusset
(G). Place a 3mm (1/8”) fillet weld on top and
bottom edges against header backtube, end panel
gusset and plate (D).
MOUNT LEFT HAND CASTER SUPPORT
D
E
POSITION & WELD GUSSET (G)
( END PANEL GUSSET REMOVED FOR CLARITY)
G