MacDon Transport 25 ft 972 - Manual (Page 21)

SET-UP INSTRUCTIONS
Form # 131126 Issue 11/07 19
REPOSITION TRACTOR HOSES & HARNESS
1. Remove female coupler from draper drive hose
at tractor left side.
2. Install 900 mm (35”) long hose (A) where
coupler was removed. Use existing dished
washer between hose (A) and bracket.
3. Attach 1/2 NPT 45 ° elbow (G) to hose (A).
4. Position new bracket (B) on tractor as shown at
right and tighten bolts to clamp in place.
5. Attach female coupler (C), removed above, to
hose (A) at new bracket, using dished washer
between bracket and coupler as shown.
6. Move reel lift coupler (D) from existing bracket
to new bracket. Install 1/4 NPT 45 ° elbow (H)
as shown. Use dished washer between bracket
and coupler as shown.
7. Insert two-prong connector (E) from existing
tractor wiring harness through smaller hole in
bracket. NOTE: Three-prong connector (F) is
from the tractor section of the transport
harness, which will be installed on the next
page. When installed, clamp both harnesses to
bracket.
NOTE: If tractor has optional hydraulic reel fore-aft
kit installed, move fore-aft coupler mount to inboard
set of holes as shown below.
TRANSPORT LIGHTS ON TRACTOR
1. Bolt lights to left tractor spring anchor as shown.
2. Repeat at right side.
REPOSITION TRACTOR COUPLERS &
HARNESS
B
A
C
D
E F
TRANSPORT
COUPLERS
FORE-AFT
COUPLERS
INSTALL TRANSPORT LIGHTS ON
TRACTOR