MacDon Transport 25 ft 972 - Manual (Page 12)

SET-UP INSTRUCTIONS
Form # 131126 Issue 11/07 10
FRONT (CUTTERBAR) WHEEL
1. At right hand header leg, remove skid shoe, if installed.
2. Weld rectangular bar (A) across bottom of leg, using a 5 mm (3/16”) weld on top surface (B) both
sides as shown below. Ensure there is no weld at edges.
3. Weld two cropped bars* (C) to sides of leg, with crop towards cutterbar as shown below. Use a 5 mm
(3/16”) weld at edges (D), both sides.
* These welded bars (C) will be present on headers built in Model Year 2001 and later.
10 mm = 0.39”
227 mm = 8.94”
259 mm = 10.20”
R/H LEG MODIFICATIONS