MacDon Transport 25 ft 972 - Manual (Page 23)

SET-UP INSTRUCTIONS
Form # 131126 Issue 11/07 21
CENTER LINK CLIP
1. For tractors with mechanical center link, install
spring clip (A) as shown at right to retain link in
raised position during hook-up.
• Remove pin from center link at tractor.
• Install spring (A) as shown (spring outlined
for photo clarity).
• Replace pin through frame bracket, spring
coil and center link ball end. Secure with hair
pin.
• Looped end of spring engages under frame
plate at (B).
HAY CONDITIONER STORAGE COMPONENTS
If header has a hay conditioner, install components
for support of conditioner during transport and
conversion to and from transport.
1. Attach bracket (C) and transfer chain (D) to right
hand tractor floorboard as at right. This chain is
only used during conversion to and from
transport.
NOTE: For high clearance tractors (XX52
models) add the short extension chain provided
to achieve proper length (see Parts Catalog page
50/51 for hardware used).
2. Attach bracket (E) for transfer chain (D) to right
side of conditioner top sheet using longer bolts
provided as shown below right.
3. Attach bracket (F) to inside of header right leg as
shown below. This bracket is used to support
conditioner in transport by engaging conditioner
support chain (G).
CENTER LINK SPRING CLIP
A
B
ATTACH TRANSFER CHAIN
C
D
SUPPORT CHAIN BRACKET
F
G
ATTACH TRANSFER CHAIN BRACKET
TO CONDITIONER
E