MacDon Transport 25 ft 972 - Manual (Page 6)

SET-UP INSTRUCTIONS
Form # 131126 Issue 11/07 4
LEFT END (FORWARD) WHEEL (continued)
IMPORTANT: Steps 8-11 are for single sickle headers, for double sickle headers proceed to step 12.
8. Bolt left hand caster mount (E) into position
against inside surface of plate (D) welded in step 7
(refer to page 6 for instruction).
9. Position triangular gusset (F) (from kit) 6mm (1/4”)
above left hand caster mount and flush against
plate (D) and backtube. Tack gusset (F) in
position.
10. Remove left hand caster mount and weld gusset
(F). Place a 5mm (3/16“) fillet weld on top and
bottom edges against header backtube and plate
(D).
11. Proceed to step 15.
MOUNT LEFT HAND CASTER SUPPORT
D
E
F
POSITION & WELD GUSSET (F)