Rockwell Automation 855T DeviceNet Stack Light User Manual - Manual (Page 26)

Publication 855T-UM001C-EN-P May 2005
Chapter
3
Installation and Mounting
Chapter Objectives
This chapter describes how to install and mount a standard or custom DeviceNet Stack Light.
It contains the following sections:
DeviceNet Guidelines
It is your responsibility to install and implement the DeviceNet Network and supported
devices according to the DeviceNet guidelines.
Equipment Needed
Install the DeviceNet Stack Light using standard electrician’s tools:
• Slotted screwdriver of standard and small sizes (one small screwdriver, required for
setting rotary switches, is included with the product)
Setting the Rotary Switches
The settings of the rotary switches on the circuit board determine:
• DeviceNet Data Rate
• DeviceNet Node Address
Table 3.A
Section Page Section Page
DeviceNet Guidelines 3-1 DeviceNet Stack Light Base Dimensions 3-4
Equipment Needed 3-1 Mounting the DeviceNet Stack Light 3-5
Setting the Rotary Switches 3-1 — —