Rockwell Automation 1756-L7x GuardLogix 5570 Controllers User Manual
Page 28
Advertising
28
Rockwell Automation Publication 1756-UM022A-EN-P - November 2012
Chapter 2
Install the Controller
To configure RSLinx software to use a USB port, you need to first set up a USB
driver. To set up a USB driver, perform this procedure.
1. Connect your controller and workstation by using a USB cable.
2. On the Found New Hardware Wizard dialog box, click any of the
Windows Update connection options and click Next.
3. Click Install the software automatically (Recommended) and click Next.
The software is installed.
4. Click Finish to set up your USB driver.
TIP
If the software for the USB driver is not found and the installation is canceled,
verify that you have installed RSLinx Classic software, version 2.59 or later.
Advertising