Rockwell Automation 1756-L7x GuardLogix 5570 Controllers - Manual (Page 32)

32 Rockwell Automation Publication 1756-UM022A-EN-P - November 2012
Chapter 2 Install the Controller
Figure 4 - Controller Keyswitch
Use the Logix Designer Application to Change the Operation Mode
Depending on the mode of the controller you specify by using the keyswitch, you
can change the operation mode of the controller by using the Logix Designer
application.
After you are online with the controller and the controller keyswitch is set to
Remote (REM or the center position), you can use the Controller Status menu in
the upper-left corner of the Logix Designer application window to specify these
operation modes:
• Remote Program
• Remote Run
• Remote Test
Figure 5 - Operation Mode via the Logix Designer Application
TIP For this example, the controller keyswitch is set to Remote mode. If your
controller keyswitch is set to Run or Program modes, the menu options
change.
OK FORCE SD RUN
Logix557x
RU
N REM PROG