Configure cip safety i/o modules – Rockwell Automation 1756-L7x GuardLogix 5570 Controllers User Manual

Page 60

Advertising
background image

60

Rockwell Automation Publication 1756-UM022A-EN-P - November 2012

Chapter 5

Add, Configure, Monitor, and Replace CIP Safety I/O

IP address for EtherNet/IP networks

To set the IP address, you can adjust the rotary switches on the module, use
DHCP software, available from Rockwell Automation, or retrieve the
default address from nonvolatile memory.

Safety network number (SNN)

See page

61

for information on setting the SNN.

Configuration signature

See page

65

for information on when the configuration signature is set

automatically and when you need to set it.

Reaction time limit

See page

61

for information on setting the reaction time limit.

Safety input, output, and test parameters

You can configure CIP Safety I/O modules via the GuardLogix controller by
using the Logix Designer application.

Configure CIP Safety I/O
Modules

Add the CIP Safety I/O module to the communication module under the I/O
Configuration folder of the controller project.

1. Right-click the appropriate network and choose New Module.

2. Expand the Safety category and choose a CIP Safety I/O module.

3. Specify the module properties.

a. Modify the Module Definition settings, if required, by clicking

Change.

TIP

Safety I/O modules support standard and safety data. Module
configuration defines what data is available.

TIP

You cannot add or delete a CIP Safety I/O module while online.

Advertising