Rockwell Automation 1770 DH,DHII,DH485 CABLE User Manual
Page 36
![background image](/manuals/579827/36/background.png)
Chapter 3
Constructing a Data Highway or
Data Highway Plus Cable System
3-4
If you have a 15-socket connector, continue with step 7. If you do not have a
15-socket connector, continue with step 9.
7.
Remove the screws that attach the right-angle hood to the 15-socket
connector and separate the hood from the connector.
Large-diameter
Shrink Tubing
(clear plastic)
Small-diameter
Shrink Tubing
(clear plastic)
Small
Screws
Locking Clip
Locking Clip
Cable Clamp
Large Screw
Pin
Holes
Right-angle Hood
10806
8.
Guide the dropline through the circular hole in the right-angle hood.
9.
Keeping the pins on the electrical connector facing up, clamp the
connector securely in a vise. Do not over-tighten the vise.
10.
Cut the small-diameter shrink tubing into three equal pieces, and slip one
piece over the drain wire, one piece over the blue conductor wire, and one
piece over the clear conductor wire.
If you have this connector:
Go to step:
3Ćposition terminal block
11
9Ćpin
12
15Ćsocket
13
62Ćpin
14