Rockwell Automation 1770 DH,DHII,DH485 CABLE - Manual (Page 96)

Constructing a DH II Cable System
Chapter 6
6-7
9. Slide the plug sleeve over the braid until it butts up against the shoulder of
the plug body.
10. Position the crimping tool over the plug sleeve as close to the plug body
shoulder as possible and crimp the plug sleeve.
The next step is to attach the trunkline cables and terminators to the tap.
Figure 6.4 shows an example of how to configure the cable segments, taps and
terminators in a network.
Figure 6.4
An example of how to configure your network.
Node
Tap Tap
Dropline
(two feet)
Tap
Trunklines
(longer than 30 feet)
Node Node
Terminator
Dropline
(two feet)
Terminator
16048
Attach the Trunkline Cables
and Terminators to the Tap