Rockwell Automation 1770 DH,DHII,DH485 CABLE - Manual (Page 83)

Planning a DH II Cable System
Chapter 5
5-7
You can order terminators from the following manufacturer:
Trompeter Electronics, Inc.
31186 Labaya Drive
Westlake, Village, CA 91311
The part numbers for the terminators are:
Component: Manufacturer Part Number:
Plug connector TNG1Ć1Ć150
Jack connector TNGBJ1Ć1Ć150
For information on installing terminators, refer to Chapter 6.
To install a DH II cable system you will need a stripping and a crimping tool for
RG-11 cable. You may use the following tools, or equivalents:
Table 5.B
Recommended stripping and crimping tools.
Part Manufacturer Part Number
Crimping Tool AMP 220015Ć1
Stripping Tool Ideal Industries 45Ć164
These manufacturers can be contacted at the following addresses.
AMP Inc.
Harrisburg, PA 17105
Ideal Industries
4450 Becker Pl.
Sycamore, IL 60178
Necessary Tools