Rockwell Automation 1770 DH,DHII,DH485 CABLE - Manual (Page 95)

Constructing a DH II Cable System
Chapter 6
6-6
4. Using a stripping tool, remove 0.2 inch (5.1 mm) of dielectric from the
end of the cable segment, exposing the center conductor.
5.1mm
(0.2 in)
7.6mm
(0.3 in)
17.8mm
(0.7 in)
Center
Conductor
Dielectric
Braided Shield and
Foil Shield
Insulating
Jacket
Coaxial
Cable
Plug Sleeve
12648
5. Push the plug pin as far as possible onto the center conductor of the cable.
Plug Pin
Dielectric
12648
6. Using a crimping tool, crimp the plug pin onto the center conductor.
7. Push the braid back against the dielectric.
8. Slide the plug body over the pin and cable end. Make sure the neck of the
plug body goes under the braid. Push the plug body as far as possible onto
the cable.
Braided Shield
Plug Body
12648