Rockwell Automation 1770 DH,DHII,DH485 CABLE - Manual (Page 51)

Constructing a Data Highway or
Data Highway Plus Cable System
Chapter 3
3-19
Important: When using a 1770-XG connector kit, droplines will have an
electrical connector attached to one end of the dropline and a plug connector
soldered to the other end. Trunkline segments will have a plug connector
soldered to one end of the cable segment and a jack connector soldered to the
other end.
Here is a brief outline of the steps you will follow as you solder a jack or plug
connector to a cable segment:
install the cone assembly
prepare the cable for soldering
solder the conductor wires
install the jack or plug connector
1. Install the cone assembly.
a. Slide the wrench crimp nut onto the cable so that the threaded end of
the nut is toward the cable end that you are going to solder to the
connector.
Wrench
Crimp
Nut
Trunkline
Segment
18733
Important: In the next step, be sure you do not damage the foil shield or the
braided shield.
b. Using wire strippers, remove approximately 1 inch (2.5 cm) of the
outer jacket from the end of the cable.
25.4mm
(1.0")
Braided
Shield
Foil
Shield
18734
Outer
Jacket