Rockwell Automation 7000A PowerFlex Medium Voltage Drive (A-Frame) - Classic Control - Manual (Page 115)

Operator Interface 3-21
7000 “A” Frame 7000A-UM150F-EN-P – June 2013
Figure 3.21 – Edit the Drive Name
Figure 3.22 – Editing Completed
Transfer Data in Memory
The operator interface contains long term storage in two forms.
Flash memory contained in the operator interface is used to store the
firmware and optionally language modules and parameters used in
the drive. This information can also be stored on a removable flash
card that can be taken to another drive.
In order to transfer information from the two forms of memory, press
the [F7] key. This displays a new screen (Figure 3.87) from which
all flash memory operations are performed. Refer to the section
entitled “Flash Memory Transfers” for instructions on these features.
Picking an Access Level
Access Levels are used in the drive to protect parameters from
unauthorized changes and to filter out the amount of information
viewed. Each access level takes on the parameters and permissions
of the lower access levels.
The default access level is 'Monitor'. In this level, only a small
subset of the parameter database is viewable. No changes are
allowed to any configuration information.