Rockwell Automation 7000A PowerFlex Medium Voltage Drive (A-Frame) - Classic Control - Manual (Page 167)

Operator Interface 3-73
7000 “A” Frame 7000A-UM150F-EN-P – June 2013
To change the segment and/or offset being viewed, press the [F7]
key. A display similar to Figure 3.102 will be shown. Each
successive press of the [F7] key toggles between highlighting the
segment and offset value. The highlighted value is the field that is
currently being edited.
Figure 3.102 – Edit the Segment:Offset
The segment:offset address is edited via the numeric keypad and the
arrow keys. All values of [0...9] can be entered directly via the
numeric keypad. To enter a value of [A...F], the [cursor up] and
[cursor down] keys must be used to cycle through the possible
values. Note that the value [0...9] can also be entered via this
method. Once a digit has been entered via the arrow keys, it must be
accepted by means of the [cursor right] key.
The value may be edited via the [cursor left] key, which acts as a
backspace to remove the last digit entered. The value is accepted by
pressing either the [enter] or [F7] key. The edited segment:offset can
be aborted by pressing the [delete] key. To accept the segment:offset
value entered, press the [enter] key. The screen will show the data at
the entered address, as shown in Figure 3.103.
Figure 3.103 – Data at New Address