Rockwell Automation 2711E-ND1 Reference Manual PanelBuilder 1400e - Manual (Page 38)

28 Control Selectors
Publication 2711E-6.15 – November 1998
Using the Set Bit Cursor Point on the PanelView Terminal
When the application is running, the operator can use these keys on
the PanelView terminal to control the Set Bit Cursor Point:
This key Does this
Select Enables the arrow keys and Home key.
Arrow keys Move the cursor through the Set Bit Cursor Points on the
screen.
Home Moves the cursor to the home position (at the top left of the
screen).
Cancel Turns the Set Bit Cursor Point feature off and disables the
arrow and Home keys.
When selected, the Cursor Point character is highlighted and
blinking. The Control is set to 1. To turn off the Set Bit Cursor Point
feature and disable the keys, the operator must press the Cancel
button on the PanelView terminal.
The Set Bit Cursor Point values are not changed when the Set Bit
Cursor Point feature is cancelled. The last selected Set Bit Cursor
Point remains on.
Note: By default, when the Cancel button is pressed, the Set Bit
Cursor Point character becomes invisible. To keep the character
visible, even after the Cancel button is pressed, enable the Retain
Cursor On Cancel check box in the Object Setup tab of the Terminal
Setup dialog box. For more information about terminal setup
options, see Chapter 12, “Configuring Terminal Setup Options” in
the PanelBuilder 1400e Configuration Software for Windows User
Manual.
Note: If you enable the Retain Cursor On Cancel option, the
application will be compatible only with PanelView Firmware
Version 2 or later. The application will not be compatible with earlier
versions.
"
"