Rockwell Automation 2711E-ND1 Reference Manual PanelBuilder 1400e - Manual (Page 89)

83 Numerics
Publication 2711E-6.15 – November 1998
Note: If you use the Extra Large Font, assign a write expression, or
configure the Numeric Input Cursor Point for implicit decimal point
operation, the application will be compatible only with PanelView
Firmware Version 2 or later. The application will not be compatible
with earlier versions.
Note: If you use the Tiny Font or the Very Tiny Font, the
application will be compatible only with PanelView Version 5 or
later. The application will not be compatible with earlier versions.
Note: By default, when the Cancel button is pressed at the terminal,
the Numeric Input Cursor Point Character becomes invisible. To
keep the character visible, even after the Cancel key is pressed,
enable the Retain Cursor On Cancel check box in the Object Setup
tab of the Terminal Setup dialog box. For more information about
terminal setup options, see Chapter 12, “Configuring Terminal Setup
Options” in the PanelBuilder 1400e Configuration Software for
Windows User Manual.
Note: If you enable the Retain Cursor On Cancel option, the
application will be compatible only with PanelView Firmware
Version 3 or later. The application will not be compatible with earlier
versions.
The Small or Large Numeric Entry Keypads enable an operator to
send numeric data to the PLC from a touch screen terminal. If you
assign the Optional Keypad Write Expression, the PanelView
terminal can perform a mathematical calculation or logical operation
on the value the operator enters, then send the result to the PLC.
Large Numeric Entry Keypad Small Numeric Entry Keypad
"
"
"
"
Numeric Entry Keypads
(Touch Screen Terminals
only)